Download and install HexUploader from here: LINK.Ensure the ‘ Baud rate‘ is set to 115200.Select the ‘ COM port‘ for your machine from the drop down list.Ensure the ‘ Device‘ selected is ‘ Uno(AtMega328).Select the Firmware file you downloaded for you your machine.Run the XLoader.exe file to start the program.Download and install XLoader from here: LINK.The new order should be: RED – BLUE – GREEN – BLACK Step 3: Update the firmwareĭownload the latest version of the Emblaser 1 Firmware from here: LINKĮnsure your Emblaser 1 is plugged a USB port and turned on. Then re-insert them as shown in the image below. Use a pin or very small screwdriver to gently depress connector clip for the red and blue wires to remove them from the connector. Step 2: Modify the motor cableĭue to revisions in the latest firmware, you will need to make a small change to the SHORTER motor cable. Proceed to the next step if you wish to trial LightBurn for 30 days. Visit our online store to purchase a LightBurn Update License Key: LINK IMPORTANT: Due to some changes in the Firmware, Cut2D-Laser may not function correctly. If you need to continue using Cut2D-Laser, we recommend not performing this update. This article will outline the steps needed to update your Emblaser 1 (A3 or A4) to the latest Firmware, which LightBurn supports. LightBurn is the new software package for the Emblaser.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |